Driveway cleaningin Coral Springs.

Concrete is one slab. It takes full pressure from the surface cleaner, it dries fast, and the only things that slow it down are oil, rust and old sealer. Pavers are hundreds of small blocks with sand between them. The face of a paver is softer than concrete and etches if the pressure is too high or the nozzle too close. The sand in the joints washes out if the pass is too aggressive, and once it is gone the pavers shift and the weeds move in.

So pavers get lower pressure, a slower pass and more attention to the joints, and if a lot of sand comes out they need re-sanding after, which is where paver sealing picks up. Travertine is a natural stone and sits between the two: harder to stain than a concrete paver, easier to chip at the edges.

Oil that dripped last month comes out with a degreaser and pressure. Oil that has been soaking into bare concrete for years has gone deep and will lighten a lot but may leave a shadow. Rust from sprinklers, fertilizer or a metal planter is iron oxide bonded to the surface and does not respond to pressure at all. It needs a dedicated rust remover, which is part of every driveway job here, and it comes out cleanly on most concrete.

Tire marks are rubber and plasticizer transferred onto hot concrete. Fresh ones wash off. Old ones on a light driveway need a degreaser and some dwell. Battery acid, paint and epoxy are not cleaning problems and Michael will tell you that instead of pretending.

Everything flat and hard around the house is the same job with the same equipment, and it is quoted together so there is one setup and one visit. Pool decks get the surface cleaner and then a careful rinse toward the drains and away from the pool. Lanai floors under a screen enclosure are done with the screen protected. Sidewalks and the city strip out front are included with the driveway if you want them, and they are usually the thing the neighbors notice first.

Stamped or colored concrete gets a lighter touch because the color is in the top layer. Coquina and shellstone, which show up on older Coral Springs homes, are soft and get treated more like a soft wash than a pressure wash.

The black film is living. When it is washed off the surface, some of it stays in the pores of the concrete and regrows from there, which is why a driveway that was pressure washed with plain water looks grey again in a few months. The post-treatment applied after the wash kills what is left in the pores, and that is the single biggest reason a Pure Clean driveway stays clean longer.

The rest is the site. Shade from a tree canopy, a north-facing drive, sprinklers that overspray the concrete every morning, and a lot that stays damp all summer will bring it back faster. Adjusting the sprinkler heads so they do not hit the drive is the cheapest thing a homeowner can do.